page 8
10. Light Kit Assembly (Optional). (cont.)
Locate hex nut and lock washer in one of the
hardware packs. Feed wires (one by one)
from light kit fitter through center hole in
switch housing cap. Then, screw switch
housing cap onto threaded rod at top of light
kit fitter, followed by lock washer and hex
nut. Tighten hex nut over lock washer for a
secure fit.
Connect
WHITE
wire from switch housing
to
WHITE
wire from light kit fitter. Connect
BLUE
(or
BLACK
) wire from switch housing
to
BLACK
wire from light kit fitter. When
making the connections, use wire connectors
that were previously removed.
* Wrap each wire connector separately
with electrical tape as an extra safety
measure.
Align holes in switch housing cap with
holes in switch housing. (
Note
: The gap
on the top edge of the switch housing
cap must align with the reverse switch
on the switch housing for the proper fit.)
Re-insert screws that were previously
removed and securely tighten all 3 screws
with a Phillips screwdriver.
Install 2 medium base 9 watt LED bulbs
(included).
IMPORTANT
: When you need to replace
bulbs, please allow bulbs and glass shade to
cool down before handling the bulbs or the
glass shade.
Remove finial and finial plate from threaded
rod at bottom of light kit fitter. Raise glass
shade in order to guide pull chains through
corresponding holes in glass shade. Align
threaded rod on light kit fitter with hole in
middle of glass shade and push up gently
allowing threaded rod to come through hole.
(
Be sure pull chain for fan operation does not
rub against bulb during operation
.) Align hole
in center of finial plate with threaded rod,
allowing pull chains to come through
corresponding holes in finial plate, and push
up. Thread center pull chain through hole in
finial and secure glass shade to light kit fitter
by tightening finial.
WARNING
: Do NOT overtighten finial as glass
may crack or break.
glass shade
finial
bulb
light kit fitter
switch
housing
pull chain
for fan
reverse
switch
pull chain
for light
finial plate
motor
housing
white wire
white wire
black wire
blue
(or black)
wire
*
threaded rod
light kit fitter
hex nut
lock washer
switch housing
cap
switch
housing cap
