8. Canopy Assembly.
page 6
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
7. Wiring.
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground (
GREEN
or Bare) wire is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions,
please use a qualified electrician.
Note
:
Excess lead wire length from the fan can
be cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be
made
as follows:
Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire
from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together
from fan to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect
BLUE
wire from
fan to the
BLACK
supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote adaptable (remote control sold
separately).
*
from
ceiling
from fan
ground
(green or bare)
canopy
slotted
hole
hanging bracket
Temporarily raise canopy to hanging bracket
to determine which 2 screws align with slotted
holes in canopy, and then lower canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist
canopy to lock. Re-insert the other 2 screws
and secure all screws with a Phillips
screwdriver.
