page 9
It is recommended that you test fan
before finalizing installation. Restore
power from circuit box and light switch
(if applicable). Test fan speeds with the
pull chain located on the switch
housing. Start at the OFF position (no
blade movement). First pull will set the
fan to HI. Second pull will set the fan
to MEDIUM. Third pull will set the fan
to LOW. Fourth pull will again set the
fan to OFF setting. Test light with the
pull chain located in the middle of the
light kit fitter. (
diagram 1
) If fan does
not function, please refer to
"Troubleshooting" section to solve
any issues before contacting Customer
Service.
Turn fan completely off
before
moving
the reverse switch. Set reverse switch
to recirculate air depending on the
season:
- DOWN position in summer
(
diagram 2
)
- UP position in winter
(
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and
lower your thermostat setting in winter
without feeling a difference in your
comfort.
Important
: Reverse switch must be set
either
completely UP
or
completely
DOWN
for fan to function. If the reverse
switch is set in the
middle
position
(
diagram 4
), fan will not operate.
Attach pull chain extension(s) provided
or custom pull chain extension(s) (sold
separately) to the end(s) of the pull
chain(s).
11. Testing Your Fan.
diagram 2
diagram 3
diagram 4
reverse
switch
motor housing
fan pull chain
extension
light pull
chain extension
switch
housing
diagram 1
