To open the door
manually:
The door should be fully
closed if possible. Pull
down on the red
emergency release
handle and lift the door
manually. To reconnect
the door to the opener,
press the Wall Control
push bar or button.
32
Activate the opener with any of the following
devices:
•
The Transmitter.
3-Function: Hold large push button down until
the door starts to move.
Single function: Hold push button down until the
door starts to move.
•
The Wall Control. Hold push bar or button down
until the door starts to move.
•
The Key Switch or Touch Code Transmitter
(See Accessories)
When the opener is activated with the safety
reversing sensor installed and correctly aligned:
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle
when the invisible beam is broken. If fully open,
the door will not close when the beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed or is not aligned
correctly, the door can't be closed from any portable
transmitter. You can close the door with the Wall
Control, the Key Switch, or Touch Code
Transmitter, however, if you activate them
until
down travel is complete. If you release them too
soon, the door will
reverse.
The opener light will
blink for 5 seconds when the
safety reversing sensor causes the door to reverse.
The Opener Light will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. It will turn off automatically after
4-1/2 minutes. Bulb size is 75 watts maximum.
The lockout feature
prevents the trolley from
reconnecting auto-
matically. Pull the
emergency handle down
and back (toward the
opener). The door can
then be raised and
lowered manually as
often as necessary. To
disengage the Lockout
Feature, pull the
emergency handle
straight down. The trolley
will reconnect on the
next UP or DOWN
operation.
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down)
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down & Back
Towards Opener)
Lockout position
Manual disconnect
position
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious injury, death or property
damage. If possible, use the emergency
release rope and handle
only when the door is
fully closed.
Press the lighted push bar or button to open or close the door.
Press again to
reverse the door during the closing cycle or to stop the door
while it's opening.
Operation of Your Opener
Operation of the Wall Control
WARNING
