Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the wall push button(s) or remote
control transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
To comply with FCC/IC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Your 18800 series garage door opener (with
receiver "SRT" button) has been factory set to
operate when you press the transmitter's (large)
push button. The additional push buttons on a
3-function transmitter can also activate other garage
door openers.
Below are instructions for programming your opener
to match the other buttons on your transmitter(s)
and any additional transmitters you may purchase.
33
Your garage door opener will learn and respond to
up to 6 transmitter codes:
A. Up to 4 "SRT" portable transmitters, Item Nos.
18305, 18306 or 18307.
B. One 390MHz, 19,683 code transmitter, Item Nos.
18778 or 18779.
C. One Touch Code Transmitter, Item No. 18776.
To Add A Transmitter
1. Select a transmitter push button to operate the
receiver.
2. Press and
hold the selected transmitter push
button, Figure 1.
3. Then press and release the "SRT" button on the
back panel of the opener, Figure 2. The opener
light will
flash once.
Now the opener will operate when the transmitter
push button is pressed.
If you release the transmitter push button before
the opener light flashes, the opener has not
accepted the code.
To Change the Selected Push Button
On the Same Transmitter
If you decide to use a different transmitter button
than originally programmed into the opener, you
must erase
all the learned codes and reprogram
each transmitter used to operate the garage door
opener.
To Erase All Transmitter Codes
• Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1, 2 and 3 for each
transmitter in use.
Select a transmitter push
button to operate opener
GARAGE DOOR
OPENER RECEIVER
(With "SRT" Button)
"SRT"
Button
Indicator
Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
18800 Series Garage Door Openers
(With "SRT" Button)
Code programming instructions are also located
on the opener panel.
Figure 2
Figure 1
3-Function Transmitter
Single Function
Transmitter
Garage Door Opener Receiver
(With "SRT" Button)
WARNING
Receiver and Transmitter Programming
Select a transmitter push
button to operate opener
Mini 3-Function
Transmitter
