Crafco SUPER SHOT 60, Parts Manual

Page: 86 / 140

Super Shot 60 Propane Melter Part Manual
Chapter 8 Troubleshooting
©2018 by Crafco, Inc. All Rights Reserved
………………...…………………………..……………...Illustrated Parts List 8-20
8.3 Hose Troubleshooting
Symptom: Hose Does Not Heat 8.3.1
Step Possible Cause If . . .
1 Is the Material Temperature Display at or
above 275°F?

Yes, go to Step 2.

No, continue to allow the machine to heat.
(Make sure the Material dial and the Hot
Oil dial are set at operating temperatures.)
2 Is the red "HEATED HOSE" light "ON"?

Yes, go to Table 8-18 Hose Electrical
Troubleshooting

No, allow the machine to heat material to
275°F.
2a Is the circuit breaker tripped?

Yes, reset the circuit breaker by pushing in
the button which has popped out.

No, go to Table 8-18 Hose Electrical
Troubleshooting
NOTE : Use Fig. 8-7 Hose Circuit Schematic while troubleshooting the hose electrical system.
Step Possible Cause If . . .
1 Is there
12Vdc between “BATT” terminal of
the generator and a nearby ground source
(lug on battery tray)?

Yes, go to Step 2.

No, go to Step 6.
2 Is there 24Vac between the white, green, and
black wires?
NOTE : Do this test inside the junction box.
Check between black and white, black and
green, and green and white. See
Fig. 8-6
Junction Box Voltage Testing

Yes, go to Step 3

No, stop the engine, tighten the belt, restart
engine and recheck output voltage.

Still no, replace the generator.
2a Check the three heating element wires (blue)
in the junction box for 30-35 Amps cold or
20-22 Amps hot.
NOTE : Always use a clamp-on amp meter to
perform this test. Each wire should have the
same amp reading (+/- 1 amp).

Yes, the hose should be working properly.

No, go to Step 3.
Table 8-17 Basic Visual Hose Troubleshooting
Table 8-18 Hose Electrical Troubleshooting