CPI User Manual for 350VA-600VA Lithium Ion Standby UPS
04/22v.1
Page 4
LS-SERIES (350VA-600VA)
Chatsworth Products (CPI)
INSTALLATION & INITIAL STARTUP
Note: Before installation, inspect the unit and packaging to make sure that nothing inside
has been damaged.
Connect UPS to Utility and Charging
Before the initial use of the UPS, plug the UPS input cord into a wall outlet and turn the
UPS on by pressing the Power switch on the back of the UPS. For best results, the bat-
teries in the UPS should be charged for at least 8 hours before use. The UPS charges its
battery while it is connected to AC utility power and powered on.
Connecting the Loads
Plug the loads to be supported by the UPS into the output receptacles on the front of the
UPS. Simply turn the power switch on the UPS on and the devices connected to the UPS
will be protected by the UPS unit.
Turn UPS ON/OFF
To turn the UPS unit on, press the power button on the UPS and hold for three seconds.
To turn the UPS unit off, press the power button and hold for one second.
Connecting Local Monitoring Software (optional)
If it is desired to use the Local Monitoring Software, and if your UPS is equipped with USB
communications, connect a USB cable from your computer to the UPS, and install the
software from the CD.
INDICATORS & ALARM CONDITIONS
Condition
Visual Indicator
Alarm
AC mode
LED illuminated
No Audible Alarm
Battery mode
LED flashes every 10 seconds
Audible Alarm sounds every 10
seconds
Low battery mode
LED flashes every 1 second
Audible Alarm sounds every 1
second
Fault
LED is illuminated
Audible Alarm is continuous
Alarm for over temperature
protection
LED flashes every 0.5 seconds
No Audible Alarm
