User Manual
351WOKR13(L/N)
www.cookingperformancegroup.com
7
Lighting Instructions
Initial Pilot Lighting
Shutdown Instructions
1. Turn the control valve to position 0, or OFF.
2. Make sure all knobs are in a closed state.
3. Wait for 5 minutes.
4.
Turn pilot valve(s) by adjusting the screw counter clockwise, then light standing pilot and adjust flame
¼" high.
NOTE:
If not lit immediately, wait 1 minute for existing gas in pipe to disperse, and try again
after 1 minute.
5. Turn ON gas valve(s) to light the main burner.
•
All Cooking Performance Group appliances are adjusted and tested before leaving the factory,
effectively matching them to sea level conditions. Adjustments and calibrations to assure proper
operation may be necessary on installation to meet local conditions or adapt to low gas characteristics;
correct possible problems caused by rough handling or vibration during shipment and are to be
performed only by qualified service personnel. These adjustments are the responsibility of the customer
and / or dealer and are not covered by our warranty.
•
Check all gas connections for leaks with a soapy water solution before lighting any pilots.
•
For complete shutdown, shut OFF gas valve(s) and turn pilot valve(s) by adjusting the screw clockwise
to shut off gas to the pilot(s).
• Wait 5 minutes before next use.
Operating Instructions
Air Input Adjustment
1. Remove control panel and unscrew damper solid screw.
2.
Rotate damper to desired opening, observe flame, and adjust to appropriate degree.
3. Tighten screw damper solid screw to ensure equipment will not get loose in transportation.
4. Reinstall control panel.
• NOTE:
When converting gas types the air input must be adjusted to ensure a clean burning flame.
• CAUTION:
When lighting pilots and checking for leaks, do not stand with your face close to the
combustion chamber.
