C
剪掉变压器上导线处的扎带
Cut the cable ties that fixing the output wires of the transformer.
D
取下变压器与
PCB
板间的所有接线端，取下变压器
Pull off the transformer connecters that connected to the main PCB. Then we can take off the
transformer
22.
充气泵的拆卸
Disassembly of the inflator pump
A
取下中心盒上盖（参考中心板的拆卸）
Take off. the PCB cover
（
refer to disassembly of main PCB
）
B
取下固定充气泵的
4
枚螺丝
Take off four screws which fixing the tie of the inflator Pump.
C
剪下扎带，拔下充气泵上的气管
Cut the cable ties, then pull the pipe out
D
剪开充气泵上导线处的扎带，取下接线端
Cut the cable ties that fixing the inflator pump wire, then disconnect the connecter.
F
用尖嘴钳夹出充气泵下面的橡皮塞，取下充气泵
Use a pliers to pull the rubber stander out, then you can take the inflator pump off.
Transformer has been
taken off
方块下各有
1
个螺丝
There is one screw in
充气泵与
PCB
板接线端
Here is the inflator pump connecter
