CozyCab A-11241, Mounting Instructions, Page: 3 / 29

June 2005
05-10386
Cab Installation
2.1) Pull roll bar pins and tip upper roll bar section down.
2.2) Tilt steering column towards seat.
2.3) Tip-up seat towards steering column.
2.4) Open engine cover –Some may choose to remove engine cover and set cover aside.
2.5) From the rear side of the tractor, there are 4 bolts that secure a mount plate to the roll
bar. Doing one side at a time, remove the two bolts that mount the support plate to the
roll bar. Attach the Cab Adapter Plate 1-42147
(Refer to Mount kit Drawing 4-14563)
to
the roll bar mount plate
(See figure 2-5).
Reinstall the same bolts with the pl ate in the
lowest position. Repeat procedure on the other side and install the second Cab Adapter
Plate.
FIGURE 2-5
2.6) Next, inspect the cab. There are 2 (Two) lifting brackets mounted at the top o f the cab.
Verify that the bra ckets and fasteners are ti ght prior to lifting the cab. Attach lifting
mechanism, lift, detach and dispose of the shipping pallet and the shipping supports.
2.7) While the cab is in the air, apply the adhesive mount padding
, (Refer to items 5, 6 and 7
on mount kit drawing 4-14563).
2.8) Position the cab over tractor. Carefully lower the cab down onto the unit making sure the
rear of the cab is pla ced over the cab adapter plates, recently installed. The rea r cab
radius-window will fit into the roll ba r area. Allow th e heater hoses to fit arou nd the left
rear side of the cab and the red electrical wire around the right rear side. Center the cab,
side to side.
(See figure 2-8
).
SEAT TILTED UP
ROLL BAR BOLTS
(REMOVE AND
RE-INSTALL)
MOUNT PLATE
CAB ADAPTER
PLATE 1-42147
CAB ADAPTER
PLATE 1-42147
Page 3 of 29