LIGHTING INSTRUCTIONS
MODEL: W251F, W252F / W351F, W352F / W501F, W502F
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A.
This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B.
BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone
in your building.
•
Immediately call your gas supplier from a neighbor’s
•
If you cannot reach your gas supplier, call the fire
department.
C.
Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don’t try to repair it, call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D.
Do not use this appliance if any part has been under
water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
LIGHTING INSTRUCTIONS
1.
STOP! Read the information on the safety label.
2.
Open cabinet door.
3.
Turn temperature control knob to “LO”.
4.
Depress and turn gas control knob clockwise
to “OFF”.
5.
Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow “B” in the information on the
safety label. If you don’t smell gas, go to the next
step.
6.
Locate the pilot. (Follow metal pilot tube from gas
control).
7.
Turn gas control knob counterclockwise
to “PILOT”.
8.
Depress gas control knob and hold in. Immediately
light the pilot with a match. Continue to hold the
gas control knob in for about one (1) minute after
the pilot is lit. Release gas control knob and it will
pop back up. Pilot should remain lit. If pilot goes
out, repeat steps 4 through 8.
•
If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the
gas control knob to “OFF” and call your service
technician or gas supplier.
9.
Turn gas control knob counterclockwise
to “ON”.
10.
Turn temperature control knob to desired setting,
usually a setting of 5 or 6 is satisfactory.
11.
Close the cabinet door.
TO TURN OFF GAS TO APPLIANCE
1.
Open the cabinet door.
2.
Turn temperature control knob clockwise
3.
Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
4.
Close cabinet door.
Page 11
Pilot is
located
on side
of burner
Temp. Control Knob
phone. Follow the gas supplier’s instructions.
to “LO”.
Gas Control Knob
Internal Outlet
Pressure Regulator
Outlet (Manifold)
Pressure T
ap
NOTE: Knob can not be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
