7. Attach Bottom Rails (5) to Corner Legs using 3-Way Rail Clamps (14)
with Bolts (19), Nuts (21) and Washers (20), and to the Center Legs with
4-Way Rail Clamps (13), as shown in Figure Q. Finger tighten nuts only.
Note:
Only finger tighten
Nuts (21) at this time.
19
14
20
21
13
19
20
21
5
5
5
Figure Q: 3- and 4-Way Rail Clamp Connections
8. Make sure all Bottom Rails are the same height from ground. Push down on
Bottom Rails to tighten Roof Cover, then securely tighten Nuts (21).
9. When Bottom Rails are all secured, proceed to the four corners and tighten the
Roof Cover ends to the Corner Tubes using the Ratchets.
Do not overtighten.
10. The Portable Garage is now ready for use. If desired, install Door Roller.
Installing Door Roller
Note:
A ladder (sold separately) and at least 2 people (one to hold the ladder) are required
for Door Roller installation.
Before starting installation, review the instructions and make
sure proper tools are available. Parts are provided to install roller to one door.
1. Connect four Male Door Tubes (26) and one Female Door Tube (25)
together, and slide them into bottom Door pocket.
25
Door
26
Figure R: Connecting Door Tubes
2. On the second Leg Tube inside the Garage, measure eight inches down from the top Cross Rail.
Hold the Butterfly Cleat (28) at that spot and in the center of the Leg Tube.
Use a center punch (sold separately) to mark two holes for the Screws.
a. Carefully drill two pilot holes on the marks using the provided Drill Bit (31). Drill just enough
to make two shallow pilot holes. Be careful not to penetrate the Roof Cover.
b. Install the Butterfly Cleat (28) using the two provided 4 x 32 Screws (30).
Note:
Butterfly Cleat shown attached to left side but may be attached to either side of Garage.
8"
Cross Rail
30
28
Second
Leg Tube
Figure S: Installing Butterfly Cleat
Page 12
For technical questions, please call 1-888-866-5797.
Item 58741
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
