6. Once the Frame is positioned, leveled and
squared, anchor the four Corner Legs (6) and
two Center Legs (1), one each side, as follows:
a. Thread the Anchor (15) into the ground near
the Leg until the top of the Anchor only extends
about 3″ above the ground. Anchor each
corner and one center leg on each side.
Note:
Verify that there are no utility lines
nearby before driving anchors.
If there are rocks
or other obstacles, holes may need to be
drilled first to allow proper anchoring.
Note:
If anchoring frame on concrete, use a
concrete anchor (not provided) in place of Anchor.
b. Insert Cable (16) through Anchor and
through Corner Leg (6) or Center Leg
Foot Plate (12) as shown.
c. Pull Cable tight and secure it using a
Cable Clamp (17). Tighten the two nuts on
Cable Clamp evenly to secure Cable.
d. Repeat for all remaining Anchors and Legs.
6
16
17
15
15
17
12
16
1
Figure H: Anchoring
Using Ratchet Tie-Downs
Note:
Use these instructions for installing
Door and Back Panels, and Roof Cover.
1. Thread strap through the Ratchet’s (24)
spindle as far as it will go.
Figure I: Strap through Spindle
2. Insert S-hook of Ratchet into hole in Corner Leg (6).
Figure J: Inserting Hook into Corner Leg
3. Raise and lower Ratchet handle to wind
and tighten strap onto Ratchet spindle.
Figure K: Tightening Ratchet Strap
NOTICE: Excessive tightening will damage
straps, Panels, and Corner Legs.
To Release a Ratchet Tie-Down:
1. Press spring-loaded bar on handle.
2. Open Ratchet handle completely.
3. Unwind the strap.
Figure L: Releasing Ratchet
Page 9
For technical questions, please call 1-888-866-5797.
Item 58741
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
