Installing Roof Cover
1. Lay Roof Cover (22) on ground next to frame, so that the inside pockets are facing up. See Figure O.
2. Tie a rope (not provided) to each eyelet on the Roof Cover, one on each end.
Note:
Another rope in the middle helps if an additional person is available.
3. Throw the opposite ends of the ropes over the frame.
4. Move to the other side of the frame and pull the Roof Cover over the frame. Make sure
that the Roof Cover is centered on the frame. There should be equal overhang on each
corner. If small adjustment is needed, two people should pull together from the same
end of the Portable Garage so that the Roof Cover does not become twisted.
Pockets
22
Rope
Bottom Rails (5) installed after Roof Cover
Figure O: Installing Roof Cover
5. Assemble a Ratchet Tie Down (24) to the strap ends of the four corners of
Roof Cover. Insert hook on Ratchet to hole in Corner Leg, and ratchet a few times
to keep corner in place (Refer to
Using Ratchet Tie Downs
on page 9).
6. Slide Bottom Rails (5) into pockets. See Figure P.
5
24
24
Figure P: Installing Bottom Rails into Pockets
Page 11
For technical questions, please call 1-888-866-5797.
Item 58741
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
