12
7. Clearing and emptying
If there is a mains power failure or if the binding machine stops functioning for some other reason, documents
in input bay area and other unbound documents can be removed as described below. If there are unfinished
documents in the machine when the power supply is restored, the machine will automatically move them forward
to the output tray. They can then be re-loaded and bound.
If the binding machine breaks down, any documents should be cleared and removed from the machine before
it is sent for service.
Clearing
If the display shows
or
remove all documents
from the input bay.
To facilitate removal of the documents, the machine is equipped with a jam clearance door.
Pull back the jam clearance door with one hand (1). Firmly grip the document(s) in the input bay
with the other hand (2) and lift them out of the machine (3).
The binding machine should then automatically
return to the normal position. However,
if it does not, press the RESTART control.
Emptying
The binding machine only needs to be emptied manually in exceptional cases (e.g. if the machine
breaks down or if there is an extended power failure).
Disconnect the mains cable before emptying the machine.
Wait for a while until the heating zone in the machine has
cooled down.
Stand in front of the machine and hold both hands in the
output tray, as shown in the figure below. Turn the outermost
drivers on both sides outward using your thumbs so that the
document is manually fed one step forward. This operation
may require some force. The drivers are designed to withstand
such force. Repeat the procedure to transport the remaining
documents forward until the binding machine is empty.
Driver
Jam clearance
door
INPUT JAM
REMOVE DOC
DO NOT INSERT
REMOVE DOC
