COVANA C-HOR, Instruction Manual

Page: 26 / 60

26 INSTALLATION INSTALLATION MANUAL
Figure 52
7) Once the I-beam is properly centered into the C-
channels using the center label (Figure 49), lock
it in place by tightening the four nuts and carriage
bolts on both ends of the I-beam (two on each
end). (Figure 50)
WARNING

Do not overtighten the bolts. Power tools must
not be used. The bolts will break or strip under
too much torque.
8) Slide the remaining panel into the C channels
and press it slightly against the I-beam. (Figure
51)
CAUTION
•
Be careful not to delaminate or otherwise
damage the panel while sliding it into the C-
channels.
•
If you have colored panels, make sure the
colored side is on top and the white side is on
the foam pieces
9) Pre-assemble two corner brackets on the 93
7/16in. (237cm) long C-channels using the 10-
24x1/2in. thread cutting screws. (Figure 52)
Repeat for the second C-channel
WARNING

Do not overtighten the screws as they could
strip.
TOP VIEW
I-beam
C-channel
Figure 49
Figure 50
Tighten
these nuts
to lock the
I-beam.
Figure 51
93 7/16in. (237cm)
C-channel
10-24x1/2in. thread
cutting screws