■
Wired Cloning Mode
To enter the clone mode, wired cloning function should be set on both host and sub radio.
Wired cloning procedures are as follows:
1)
Press and hold the Side Button 1 and 2 on the host radio while turning on the radio; about 2
seconds later, orange indicator flashes twice and the radio enters cloning mode.
2)
Press once the PTT button on the host radio, and then the sub radio to receive data will enter
Wired Cloning Mode.
3)
In the cloning mode, the host radio lights red indicator and the sub radio lights green indicator.
Note: During the course of cloning, if the radio models or software versions doesn’t match, the
host radio flashes red indicator (0.25s On 0.25s Off), and the sub radio restart; if no data is
transferred, the host radio flashes red indicator (0.25s On 0.25s Off), and the sub radio restart.
■
Radio Setting
TOT (Time-out Timer)
1)
TOT (Time-out Timer)
a) Time-out timer is to prevent any caller from occupying one certain channel and radio
transmitting overlong.
b) You can program the time-out timer, i.e. the time the radio can transmit continuously. If the
radio has been transmitting continuously longer than the preset time, the radio will stop
transmitting and warning tone sounds, and please release the PTT button.
2) TOT Re-key
a) TOT re-key specifies the time when transmission is prohibited after the time-out timer is
activated.
b) During the time of transmitting prohibition, if you press the PTT button, warning tone sounds
and transmitting is prohibited.
3) TOT Pre-alert
a) Before the time-out timer stops transmitting, the radio sounds pre-alert tone.
b) After the alarm tone, if the transmitting time is longer than the preset time limit, the time-out
timer will be activated.
4) TOT Reset
a) TOT Reset is the delay time between releasing the PTT button and resetting the time-out
timer.
b) If the time of releasing the PTT button is shorter than the TOT Reset, the countdown of
transmitting prohibition will continue.
Battery Save
The dealer can program the battery save type.
15
