Costway GOPLUS SP36991, User Manual

Page: 9 / 10

16
www.costway.com
17
www.costway.com
No ti ce : do not over lubrica ti ng , reasonable lubrica ti ng can prolong life of treadmill .
2. Methods of lubrica ti ng
To check whether your treadmill needs lubrica ti ng , you can hold the running belt and put the
other hand to touch the bo tt om center of running belt , if you can feel the wet silicone oil that
means it does not need lubrica ti ng . if you feel the running belt is very dry that means your
treadmill needs a lubrica ti ng .
A : How to lubrica ti ng ( as picture )
B: stop and fold the treadmill
C:Raise the running belt on the base , then try to put the silicone oil pot under the running belt
and smear the silicone oil on the belt and both sides of the treadmill , then set 1 Km/h to make
sure silicone oil lubricates well , you can step the running belt from le
ft to right to improve the
lubrica ti ng e ff ect .
3.
Elas ti c tendency adjustment of running belt
Every treadmill would set the elas ti c tendency before it leaves factory and a ft er assembly , but it
will become loose a ft er using for a period .
Just like it will stuck or slide some ti mes , you can turn the adjus ti ng bolt in clockwise direc ti on ,
semi-circle a ti me ( le ft and right at the same ti me ) to adjust the running belt . Don’t make it too
loose or too tig ht , or the running belt will slide or make motor over load .
4. Running belt devia ti ng .
There are some factors causes this situa ti on :
Running belt
Running Board
A: the treadmill is not placed in fl at fl oor
B: User does not step on the centre of the running belt
Just set the treadmill
fl at and run idly will solve the issue : A.
If the devia ti ng s ti ll exists , you can adjust it with 6mm Allen wrench in a quarter
turn .Devia ti ng is out of warranty . User can maintain it by the instructions below : Please fi x it as
soon as you fi nd the problem or it will break the running belt .
If devia ti ng turns to right , then turn If devia ti ng turns to le ft , then turn
the le ft screw in counterclockwise the le ft screw in clockwise direc ti on,
direc ti on, turn the right screw in turn the right screw in counterclockwise
clockwise direc ti on direc ti on
A: Turn the screw in clockwise direc ti on with Allen wrench
B: Adjust the intensity , when the running belt will not slide during load is ok ( clean the debris
between belt ditch and belt wheels )
Common malfunc ti on and solu ti on
Malfunc ti on Cause Solu ti on
Treadmill can
not work
unplug Plug the power cord
Single wire or power
supply broken Check signal wire
Switch o ff Switch on
Running belt
does not move
smoothly
Not enough lubrica ti ng Lubricate with silicone oil
Running belt is too ti ght Adjust the intensity of the running belt
E01 Communica ti on failure Check the lines if connected properly
E02 Motor line fall o ff Check motor lines if loosen or fall o ff
E05 Overcurrent protec ti on Restart the machine
E07 Safety lock fall o ff Place the lock on the yellow area of the
panel