Costar Video Systems CDI2110VIRFH, Installation Manual

Page: 13 / 26

Part 1 – Introduction
13
Lens
A Motorized focus and zoom lens
When installing or handling the camera, be careful not
to give an impact on the lens to prevent a malfunction
from occurring.
I/O Device Port
1
2
3
6
4
5
1
Network Port
2
Video Out
3
Power
4
FGND (Frame Ground)
5
Audio In/Out
6
Alarm In/Out
• Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
INIT operation manual
.
• Video Out (CVBS)
Connect the cable's signal line and ground line to
these ports and the connector on its opposite end to
a monitor. Use these ports for previewing video and
not monitoring video. Go to Remote Setup (
System
>
General
) and choose a video out signal. (NTSC or
PAL)
•
Power (DC12V)
Connect this to the power adapter. A A-type jack
is used for the power adapter. (External diameter x
internal diameter: 5.5 x 2.5)
•
FGND (Frame Ground)
Used to ground the device.