Modello - Modèle - Model VELNSxx
Modell - Modelo - Modelo
SILK C - SV
STATE REVISION
ORD.
B
DATE
26.08.2020
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
Epta Spa - Unità locale:
Via degli Alpini 14 - 32020 Limana
(BL) ITALIA Tel. 0437/9681 Telefax 0437/967434
PAGE:
36/53
N° DOC.
UM000442
• Allow a couple of hours before loading the products back again.ser.
3) Clean the condenser at least one time a year with a hard non-metal brush, taking off dust and
dirt from between the fins. To access the condenser, it is necessary to disconnect the appliance
from the power mains and then remove the appropriate rear guard detaching it from the magnets
(see fig. 23 on page 7). A dirty condenser cools imperfectly, so causing waste of energy and poor
performance. Wear heavy-duty gloves when cleaning the condenser.
4) Defrost the display case every three months to let the ice that may have formed between the
evaporator fins melt, since frost may otherwise prevent correct operation. Proceed according to
the instructions for cleaning the inside surfaces, item 2, but allow a longer wait time for the ice to
melt completely.
Any maintenance operation not dealt with above, must be carried out by the authorised after-sales
service or by qualified personnel.
11. EMERGENCY SITUATIONS
1) The cabinet will not start or will not keep on working:
• there may be a general blackout;
• the wall main switch may be off;
If power failure is not due to any of the above causes, call the nearest after-sales service
immediately, empty the showcase and store the foods in coldrooms or refrigerators that
may ensure their preservation temperature.
2) The showcase will not cool properly
• the condenser may be dirty and therefore unable to exchange heat. If it is obstructed with dust
or dirt, clean thoroughly as explained in section 10;
• make sure that the product load is correct;
• if the showcase has not been defrosted for longer than 3 months, defrost and clean it before
starting normal operation (see section 10, item 3);
• make sure that the case is not exposed to sources of heat or draught;
• Check that the display case is perfectly horizontal by the use of a spirit level and that ambient
conditions comply with the requirements of page 18 - tab.II.
Should insufficient cooling persist, resort to the nearest after-sales service.
IN CASE OF A GAS LEAK OR FIRE, do not breathe inside the room that houses the cabinet before
having aired it properly. Turn the cabinet off by the main switch ahead (see fig. 17). DO NOT USE
WATER BUT ONLY DRY EXTINGUISHERS TO PUT OUT THE FIRE.
3) The cabinet operates noisily:
• make sure that screws and bolts are securely closed;
• check that the showcase is perfectly horizontal by the use of a spirit level.
Should the inconvenience persist, resort to the nearest after-sales service.
12. AFTER-SALES SERVICE
Should it be necessary to resort to technical assistance, contact your sales person immediately. If
spare parts are needed, always refer to your after-sales service: insist on the use of original spare
parts. Scroll the Italian and European network of branch offices on the back of this manual for ad
-
dresses and phone numbers.
Summary of Contents for SILK C
Page 58: ......
