18
WEEKLY MAINTENANCE
CLEANING THE SQUEEGEE TUBE
Every week, or whenever suction seems to be unsatisfactory, check the squeegee tube is not
obstructed.
To clean it, proceed as follows:
Unthread the tube from the sleeve on the squeegee
Remove the other end from the recovery tank
Wash the inside of the tube with a water jet introduced from the side where it is connected to the
tank
To reassemble the tube, repeat the above-mentioned operations in the reverse order
WARNING!
Do not wash the tube running between the suction unit and the suction
cap.
CLEANING THE SOLUTION TANK
Loosen the solution tank cap
Rinse with a jet of water
Remove the drainage cap (1) and empty the tank
WARNING!
This operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
1
REPLACING THE SQUEEGEE RUBBERS
Verify that the state of wear and tear of the squeegee rubbers and, if necessary, replace them.
To replace it you must:
1.
unthread the squeegee tube from the sleeve
2.
Remove the pin from the small column
3.
dis-assemble the squeegee from its support
4.
Loosen, by two turns, the knobs (1) blocking the rubber-pressing blades, and remove them
5.
replace the rubbers
To reassemble the squeegee, repeat the above-mentioned operations in the reverse order
1
