Connecting to a Gas Cartridge
•
If the torch is fitted to an empty cartridge, then please
read “Removing Cartridge”.
•
Remove the glass and stone before removing the
attached cartridge.
•
This torch is fitted with a sealing washer. Check the
sealing washer is present and in good condition before
connecting the cartridge.
•
Do not use if the seal is damaged or worn.
•
Do not use appliances that are leaking, damaged or do
not function properly.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames, any other
ignition source and other people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Screw out the cartridge cover anticlockwise; attach the
gas cartridge and screw in the cartridge cover
clockwise.
If there is a smell of gas or you suspect a leak once the
cartridge has been fitted, take the appliance to a well-
ventilated outdoor location away from any ignition
sources. If you want to check for leaks in your appliance,
do so outside. Do not try to detect leaks using a flame; use
soapy water.
•
Replace stones and glass as instructed, then put a
layer of stones in. The stones shall not cover the
burner.
•
Slowly open the control knob anticlockwise (ON) and
hold a lighted match near the burner.
•
If the burner does not light after 5 seconds, turn off gas
valve and wait 10 seconds before re-lighting.
•
If unit does not light after several attempts, contact your
retailer.
•
Avoid moving the torch once lit because this could be
dangerous.
•
Always operate the torch at least 50 cm away from walls
and ceilings and never near flammable materials.
CAUTION: accessible parts of this torch may become very hot
during and after use. Handle with care. Keep young children away
from this appliance.
•
Extinguish by turning control knob fully clockwise (OFF).
Check that torch is fully extinguished before leaving unattended.
Removing the Cartridge
•
Only change gas cartridges if they are empty.
•
Make sure the torch is off by turning the control knob fully anticlockwise and checking that the torch
has fully extinguished.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames and any
other ignition sources.
•
Remove the glass and stone before removing the cartridge.
•
Dispose of in accordance with the instructions printed on the cartridge.
•
Screw out the cartridge cover anticlockwise; move the gascartridge out by hand
•
Screw in the cartridge cover clockwise if not connecting to gas
190 gr gas
cartouche
Lock gas
cartouche
sealing
