Cosen V2230NC, Instruction Manual

Page: 56 / 122

4 ‐ 22
PLACING WORKPIECE ONTO WORKBED
Step 1 – Press the s aw bow backward button until the saw bow reaches rear limit position.
Step 2 – Open the vise.
Step 3 – Carefully place the workpiece onto the work feed table.
POSITIONING WORKPIECE FOR CUTTING
Follow these steps to position your workpiece:
Step Action
vises clamp material
1
Press the left and right vise clamp buttons until the workpiece
is securely clamped.
confirm cutoff point
2
Press the saw bow forward button to move the saw bow until
it is about 10mm (0.4 inch) behind the workpiece.
precision position
3
Adjust until the cutoff point on the workpiece aligns with the
blade line.
ADJUSTING COOLANT FLOW
Step 1 – Press the saw blade start button to start the saw blade drive motor.
Step 2 – Press the saw bow forward button to move the saw bow forward.
Step 3 – Use the flow control valve (shown below) to adjust the amount of fluid flowing to the cutting
area.
Adjust the flow amount if you observe the following changes to the chips generated from
cutting.
If the chips are sharp and curved, increase the coolant
flow amount.
If the chips are granulated, decrease the coolant flow
amount.