Cosen SH-5542, Instruction Manual

Page: 45 / 100

4 ‐ 13
ADJUSTING SAW ARM
Adjust the blade guide (guide arm) position based on the size of your workpiece:
Step 1 – Loosen the inserts by unlocking the lock bar.
Step 2 – Loosen the blade guide locking handle. Then adjust the guide arm to a position suitable for
your workpiece size.
Step 3 – After adjustment is made, tighten the blade guide locking handle.
Step 4 – Clamp the inserts back by locking the lock bar.
ADJUSTING COOLANT FLOW
Step 1 – Press the saw blade start button to start the saw blade drive motor.
Step 2 – Press the saw bow down button to lower the saw bow.
Step 3 – Use the flow control valve (shown below) to adjust the amount of fluid flowing to the cutting
area.
Adjust the flow amount if you observe the following changes to the chips generated from
cutting.
If the chips are sharp and curved, increase the coolant
flow amount.
If the chips are granulated, decrease the coolant flow
amount.
Blade Guide Locking Handle
Inserts Lock Bar