Cosen SH-5542, Instruction Manual

Page: 41 / 100

4 ‐ 9
Vise pressure regulator

This adjustment valve is used to control vise pressure.

Adjust vise pressure based on the material of your workpiece.

When cutting pipes or soft materials, reduce vise pressure to prevent
exerted pressure from damaging the workpiece shape or exterior.
Do not adjust vise pressure at any time during cutting.
Vise pressure should never be lower than 8 kg/cm
2
.
OPTIONAL ACCESSORIES
Vibration damper
The vibration damper can be assembled to the left saw arm. This
optional accessory is extremely useful in reducing the high ‐ frequency
noise produced when cutting large ‐ sized material.
Chip conveyor
Chip conveyor is a spiral device to bring chips out during cutting.
As a regular maintenance, remove the chip conveyor and clean all chip
deposits inside.
Hydraulic top clamp
The top clamp device is installed on the cross beam. Before executing
bundle cutting, open the flow control valve so the top clamp can move
in sync with the vise.
Note the allowable clamping width and height. (Refer to Specifications
of section 2 – General Information.)
Pressure
gauge
Pressure
adjusting
valve