Cosen MH-460M, Instruction Manual, Page: 47 / 88

4 ‐ 13
ADJUSTING HORIZONTAL STOP SPRING CUSHION
Always make sure the power cord is disconnected from power source when making
adjustments.
Complete Cut – Adjusting Horizontal Stop Spring Cushion
The workpiece should be able to cut through completely. If it does not, please follow these steps to
adjust the horizontal stop spring cushion.
Step 1 ‐ Place a level on the workbed (Fig 10, #4)
to make sure the bed is level.
Step 2 ‐ Loosen the lock nut (Fig 10, #3) and
lower down the saw bow. Place the
level on top of the saw blade (Fig 10 ‐ A)
to check its leveling against the bed
horizontal line. Adjust the screw (Fig 10,
#2) until the blade is level.
Step 3 ‐ Tighten the lock nut (Fig 10, #3) when
leveling is obtained.
If the saw blade top line is not leveled
against the bed horizontal line, the workpiece
will not be able to cut off completely.
Automatic Shut ‐ Off – Adjusting Horizontal Stop Spring Cushion
The motor should shut off immediately after the blade has cut through the material and right before
the head comes to rest on the horizontal stop spring cushion. If it does not, the spring cushion must
be adjusted.
1. Check the horizontal stop spring cushion. Refer to “Complete Cut – Adjusting Horizontal Stop
Spring Cushion.”
2. Raise the saw head and press the power on button to ON. Lower the saw head slowly and
observe the switch mechanism.