Cosen MH-460M, Instruction Manual, Page: 45 / 88

4 ‐ 11
ADJUSTING WIRE BRUSH
Follow these steps to adjust wire brush to appropriate position:
Step 1 ‐ Open the drive wheel cover.
Step 2 ‐ Adjust the screw to make brush move up / down until it makes proper contact with the saw
blade (see below illustration).
Step 3 ‐ Close the drive wheel cover.
Proper Improper
ADJUSTING SAW ARM
Adjust the blade guide (guide arm) position based on the size
of your workpiece:
Step 1 – Loosen the blade guide locking handle. Then adjust
the guide arm to a position suitable for your
workpiece size.
Step 2 – After adjustment is made, tighten the blade guide
locking handle.
CUTTING IRREGULAR CROSS SECTION
When cutting irregularly ‐ shaped material, if possible, avoid positioning the work in the way that the
cut would be started on a sharp corner. Arrange your workpiece in the way that as many teeth as
possible will be applied to the work at one time.
Locking Handle