Cosen C-325NC, Instruction Manual

Page: 65 / 110

OPERATING INSTRUCTION
SECTION 4
4-28
(1) Reduce the blade speed to one-half of its normal setting.
(2) Lengthen the cutting time to 2-3 times of what is normally required.
(3) The complete break-in operation requires cutting on a 645 mm
2
(25.4 square inches) section for 5
times.
(4) After the break-in operation is completed, set all parameters back to normal settings.
4.7 STARTING AN AUTOMATIC OPERATION
Step 1 –
Use manual mode and cut the edge of the workpiece by using the same procedures as those
described under manual operation.
Step 2 –
After the trim cut is completed and the saw blade has stopped at the lower limit position,
press the saw blade up button to raise the saw bow until the quick approach bar is
approximately 10mm (0.4inch) above the workpiece.
Step 3 –
Turn the Auto/ manual switch to manual.
Step 4 –
Set your desired cutting length and quantity via the HMI touch screen. A total of 100 sets of
cutting data can be programmed.
Step 5 –
Turn the Auto/ manual switch to Auto.
Step 6 –
Press the saw blade start button and press the saw bow down button to start automatic
cutting.
Using top clamp for bundle cutting
Installing top clamp
To perform bundle cutting, use the top clamps and take the following installation procedures.
Step 1 –
Install stud bolts on the front and rear vises and position the top clamp.