Cosen C-325NC, Instruction Manual, Page: 76 / 110

HYDRAULIC SYSTEM
Section 6
6-1
SECTION 6
HYDRAULIC SYSTEM
6.1 INTRODUCTION
The band saw model for your device is a hydraulic driven automatic machine. Most of the
movement of the machine elements are powered by the hydraulic system. In the front of drive wheel
installed one set of tension adjusting part, used on adjusting the tention as saw blade required. The
hydraulic cylinder provides pressure to clamp material.
CAUTION
During installation or handling of higer pressure hydraulic hoses do not bend hose to smaller
than specified minimum bend radius. Installed higer pressure hoses removed for other
maintenance assessibility should be reinstalled in same location. These hoses develop a
permanent set and straightening action could cause damage to the inner liner. Any sharp bends
or bumps could cause liner to collapse and result in system leakage.