4
5
CORNING LSE MULTI PURPOSE DIGITAL VORTEXER
Instruction Manual
1.0 General Description
1.1 Definition
The Corning® LSE™ Multipurpose Digital Vortexer is intended for vortexing microliter
plates, tubes, bottles, flasks, dishes, and other laboratory vessels. The Vortexer is driven
by asynchronous motors, which enable silent operation and constant shaking speed,
independent of the load or power supply fluctuations.
1.2 Principles of Operation
Each Vortexer device consists of two main components:
◗
◗
Motor with eccentric mechanism
◗
◗
Control electronics
The motor drives the Vortexer’s eccentric mechanics and generates the shaking effect.
The electronics control the motor RPM, TIME, and keyboard functions.
2.0 Technical Features
2.1 Construction
The Vortexer housing is made from a high-grade, cold rolled steel plate and painted with
a highly resistant polyurethane lacquer.
2.2 General Specifications
Power Supply
115V/60Hz or 230V/50Hz
Motor Power
15W
Fuse
2 x 0.25AT, 230V
2 x 1AT, 115V
Operation Range
4°C to 65°C, 85% RH
RPM (Digital Load Independent)
100 to 1,200 rpm in 10 rpm intervals
Motion/Orbit Size
Circular, 3 mm
Timer
• 30 seconds to 99 minutes 50 seconds in 10-second
intervals
• <10 minutes in 1-second intervals
• Continuous when using timer HOLD function
Load
4.4 lbs. (2 kg)
Dimensions (W x L x H)
10.3 x 13.3 x 5.1 in. (26.2 x 33.7 x 13 cm)
Weight
16 lbs. (7.3 kg)
3.0 Installation
3.1 Unpacking
Before starting installation, carefully examine the Vortexer for damage or missing parts.
◗
◗
Open the box and lift the device together with inner packing out of the box.
◗
◗
Remove the inner packing and check that the Vortexer has not been visibly damaged
during transportation. Keep the packing material until you are sure that the Vortexer
works properly.
◗
◗
Check information on the rear data label and verify the following are correct:
• Model
• Serial number
• Electrical rating
Should any kind of damage have occurred during transportation, immediately notify the
carrier. The carrier is responsible for correcting damage caused in shipment.
3.2 Selecting a Suitable Location
When selecting a location for the Vortexer, please consider the following:
◗
◗
Put the device on a smooth, horizontal, and stable surface.
◗
◗
Leave enough space around the device for normal air circulation, minimum 10 cm.
◗
◗
Leave enough space around the device so that it can easily be controlled and
maintained.
◗
◗
Do not use the device in surroundings where there are major temperature and
humidity fluctuations. Also avoid locations in direct sunlight or places near devices
that produce heat.
◗
◗
Avoid locations with excessive vibrations.
3.3 Attaching the Power Cord
Fit the main power cord, which is included in the package, into the power receptacle on
the Vortexer. Connect the other end of the cord to a properly grounded wall outlet. To
avoid interference from noise, surges, and spikes, a dedicated line is preferred. If no such
line is available, avoid lines to which powerful electric motors, refrigerators, and similar
devices are connected.
Take care when you plug the cord to a grounded wall socket. Do not touch
the plug with wet hands. Plug the cord to a grounded wall socket only with
a dry hand.
