Page 11
SRP 003-304 • Issue 9 • July 2004
13.3
Route cable through the guides as shown
in Figure 24 and plug in connectors. Refer to
the connector installation instructions in
Section 11 and the fiber precautions in Section
3 to avoid damaging the cable during
installation.
14. Maintenance
The unit requires very little maintenance to
make sure fibers and parts remain in good
condition.
Loose Parts
: Check nuts, bolts and screws for
looseness and tighten.
Moisture:
Check the housing for accumulated
moisture and place moisture absorbent
packets as needed.
Fiber Bends:
Check fiber optic cable to make
sure bends do not exceed the minimum bend
radius. Check cable for unnecessary strain.
Check cable entries and exits for crimping
or crushing.
Documentation:
Check record label to make
sure it is clear and accurate.
15. Specifications
The unit weighs 4.3 kg (10 lb)
f) Trim off the excess yarn and central
member.
g) Reinstall the strain-relief bracket.
NOTE:
The exposed length of the central member
(after strain-relief) is to be less than or equal to 6.5
cm (2
1
/
2
inch) between the U-shaped washer and
the end of the cable sheath.
NOTE:
For full optimization, the bracket will
accept three U-shaped washers and each U-shaped
washer will accommodate two central members, one
on each side of the screw.
Figure 24
31.7 cm
(12.5 in.)
26.7 cm
(10.5 in.)
16.5 cm
(6.5 in.)
