1
Instruction Manual
1.0 Safety Information
CAUTION:
Risk of danger – there is material in the instruction manual which must
be read, understood, and followed to preserve safety operations and features.
Ensure that only trained staff or personnel work with the instrument.
CAUTION:
Caution during experimentation as the housing and the microtube shaker blocks
can be programmed to reach a temperature of 110°C. Refer to specifications.
Pay attention to the residual heat during block exchange and powering off –
risk of burn.
Protective ground contact
The socket must be grounded before each use.
When working wear personal protective equipment (PPE) to avoid the risk from:
–
Splashing and evaporation of liquids
–
Release of toxic or combustible gases
Set up the instrument on a level, stable, clean, non-slip, dry, and fire resistant
surface. Do not operate the instrument in explosive atmospheres, with
hazardous substances, or under water.
Always power off before fitting accessories.
Temperature must always be set at least 50°C lower than the fire point of the
media used.
Be aware of hazards due to:
–
Flammable materials or media with a low boiling temperature
–
Overfilling of media
–
Incorrect use of accessories
Process pathogenic materials in closed vessels only.
Ensure the instrument and accessories comply with the safety and set up
instructions stated in this manual.
Do not use damaged components. Safe operation as described in this manual
is applicable with the accessories provided by Corning. Accessories must be
securely attached to the device.
The instrument can only be disconnected from the main power supply by
disconnection from the main or the connector plug. The main wall socket plug
is the preferred power disconnect method.
The voltage stated on the label must correspond to the main power supplied
from the region’s facility.
Ensure that the main power supply cord does not touch the microtube shaker.
Do not cover the device.
The instrument may only be opened or serviced by authorized service technicians.
The Axygen® Microtube shaker is for research use only.
