Cornelius signature, Service Manual

Page: 44 / 54

Signature Service Manual
Publication Number: 621058426SER - 40 - © 2011, IMI Cornelius Inc.
Power Entry Module
Replacement for 230VAC
Units
Figure 57. AC Filter Connections
C
OMPRESSOR
C
APACITOR
R
EPLACEMENT
The compressor start and run capacitors, shown in Figure 58, are mounted in the E-Box
on the left side of the unit. To replace a capacitor, perform the procedure in Table 28.
Table 27
Step Procedure
1 Remove the left side panel from the unit.
2 Locate the filter assembly mounted to the rear panel, as shown in Figure 57.
3
Label and disconnect the AC connections to the rear of the filter. (See Figure
57.)
4
Compress the spring tabs on the top and bottom of the filter and push it out
the rear of the unit.
5 Install the new filter through the rear of the unit.
6 Connect the wires back to their proper locations on the new filter.
7 Replace the side panel.
8 Reconnect power to the unit.
Spring Tab
AC Connections
Table 28.
Step Procedure
1 Disconnect power from the unit.
2 Remove the left side cover and the E-Box cover.
3 Disconnect the harness from the defective capacitor.
4 Loosen the mounting screw on the strap holding the capacitors.
5 Replace the capacitor.
6
Reverse the procedure to install the new capacitor. Make sure the labels on the
capacitors are readable after replacement.
7 Replace the E-Box cover and the left side panel.
8 Reconnect power to the unit.