Cornelius signature, Service Manual

Page: 36 / 54

Signature Service Manual
Publication Number: 621058426SER - 32 - © 2011, IMI Cornelius Inc.
P
ADDLE
M
OTOR
R
EPLACEMENT
There are two paddle motors located at the top of the unit. These paddle motors are
located under the Product Bowl. They are accessed from the top of the unit when the
Product Bowl is removed. To replace a paddle motor, perform the procedure in Table 19.
Figure 45. Paddle Motor Connectors
Table 19.
Step Procedure
1 Empty any product from the product bowl.
2 Disconnect power from the unit.
3 Remove the product bowl and paddles from the top of the unit.
4 Remove the left side panel from the unit.
5
Remove the control board cover by loosening the mounting screws, from each side
of the cover and lifting the cover off the two tabs at the top, as shown in Figure 36.
6
Disconnect the paddle motor by disconnecting the motor leads from the connec-
tors located near the control board on the left side of the unit, shown in Figure 45.
7
Remove the two screws holding the paddle motor cover onto the top of the unit,
as shown in Figure 46.
8
Pull the motor out the top of the unit, as shown in Figure 47. There are no mounting
screws holding the motor.
9 Replace the motor.
10
Place the paddle motor cover over the motor and reinstall the two screws that hold
the cover down.
11
Reconnect the paddle motor leads to the connectors located at the bottom of the
control board, as shown in Figure 45.
12 Replace the control board cover and tighten the two retaining screws.
13 Reinstall the left side panel onto the unit.
14 Replace the product bowl and paddles on the top of the unit.
15 Reconnect power to the unit.
16
Press the CLEAN Button to place the unit in Clean Mode and verify paddle opera-
tion.
Control
Board
Paddle Motor
Connectors