Triton R134a Range
Manual operation undercounter cooler
Triton R134a Range
Page 8
Cornelius Deutschland GmbH
Document no: TD1014600EN
Version A, 24.09.2019, Index 0
Caution!
Component damage due to freezing liquids
Ambient temperatures that are below freezing will lead to the freezing of any water or cleaning agent
residue remaining inside the unit. This will lead to damage to internal components.
Before shipment, storage or relocation of the unit, the unit is to be cleaned and the cleaning solution is
to be fully drained from the unit.
3
Installation Requirements
(To be done only by « expert »)
3.1
Installation Sites
Comply with the valid national regulations for installation sites and electrical connections. Ventilation of
the installation sites must be appropriate for device output. Inadequate ventilation of the device will
result in its overheating and being destroyed. Always make certain that no intake or discharge vents are
covered.
Triton 150 Procon
Triton 350
Triton 700 Triton 2500
Heat output 1200 W 1700 W 2000 W 3000 W
Air flow 150 m
3
/h 360 m
3
/h 450 m
3
/h 850 m
3
/h
3.2
Electrical Connections
A socket outlet with an earthing contact featuring a maximum protection of 16 amperes is required.
The line voltage must always be within following tolerances: 230 VAC +6%/-10% / 50 Hz
Triton 150 Procon
Triton 350 Triton 700 Triton 2500
Max. Power consumption 950 W 1200 W 1300 W 2400 W
Max. current
5 A
6,5 A
6,5 A
11,5 A
For the Triton 2500 devices, the operator must ensure that the maximum system impedance at the point of
connection to the public low-
voltage supply is less than or equal to Zmax of 0.173 Ω. If necessary, the operator
must consult with the responsible electricity supply company.
4
Installation
-
The device must be installed by a trained service technician.
-
Please take care, that the socket for the unit is always accessible.
-
There is no user serviceable items inside the equipment.
-
If the power supply cable to the unit is damaged, it has to be replaced by the manufacturer, the service
partner or any other qualified person to avoid safety hazard.
-
Minimum clearance to walls is 0.3m
4.1
Water Connection
Connecting only to drinking water!
Tubing set not included.
Connect the device to a feed line with an inner diameter of 10 mm. We recommend using a water filter and a
water pressure regulator for the water input. To permit flushing of the filter, a t-piece should be mounted
downstream of the water pressure regulator. The water flow pressure must be minimum 0.2 MPa (2 bar) and
maximum 0.4 MPa (4 bar) (mount control pressure gauge on water pressure regulator). A flow rate of 560
liters/hour is required. Due to the high flow rate, it may be necessary to install several water filters and water
tubes in parallel.
