Cold Nitro Brew BIB Dispenser Installation Manual
Publication Number: 621058723INS
‐
13
‐
© 2017, Cornelius Inc.
7
(Optional) If required, install the water booster pump either
onto the back of the CNB BIB cabinet (if clearance space is
available) or onto the wall by securing its base bracket with
appropriate mounting hardware. Two holes are supplied on
the back of the unit for mounting the booster pump assem
‐
bly. Place booster pump less than 10 feet away from the unit.
WARNING:
Due to a potential hot surface of the pump motor
casing, the booster
‐
pump assembly must be installed in a loca
‐
tion where it is not accessible by users.
Water Booster Pump
Booster Pump Mounted
8
Connect the source water line to the cabinet Water inlet (or
to the optional booster pump inlet).
A. Connect the 3/8” ID tubing to the water source fitting.
B. Route the tubing from the water source to the CNB BIB
Water inlet as shown in figure 1 (or to the water booster
pump inlet, shown at right).
C. Connect the tubing using a hose clamp.
9
(Optional) If the water booster pump is required connect the
water line to booster pump outlet.
A. Connect the 3/8” ID tubing to the water booster pump
outlet using a hose clamp
10
Connect water line to dispenser Water inlet.
A. Route the tubing to back of the CNB BIB cabinet.
B. Install it on the cabinet water inlet using a hose clamp.
11
Connect the drip
‐
tray drain line and elbow.
A. Route the 3/8” ID tubing to the selected drain location.
ensure there are no restrictions or kinks in the tubing.
B. The drain tubing assembly is factory installed. The gray
elbow can be removed by twisting and pulling. It is
assembled by friction and NOT glued in place.
C. Ensure the strain relief is mounted to the rear of the
machine.
Table 2
Step
Action
Water
Nitrogen
Inlet
Port
Inlet
Port
Summary of Contents for CNB BIB
Page 41: ......
