Cormach MOTO MEC, Use And Maintenance Manual

Page: 26 / 36

Use and maintenance manual – 10/2016 Rev. 3 Page 20
The balancing of wheel type QUAD could be performed also with ALU Program Type by pressing the button [P8] ; STATIC
Program Type by pressing the button [P10] .
15.3 Entering wheel dimensions
The dimensions of the wheel to balance can be entered in manual mode only.
Note: all the machines are equipped with a graduated scale for manually measuring the distance.
To manually introduce the wheel size, proceed as follows:
1. Fit the wheel on the shaft and tighten it with the ring nut.
2. Extract the distance sensor and place it on the wheel as shown in Figure F15.3;
3. Read the distance value on the graduated scale as shown in Figure F15.3. The distance value is always expressed in
millimetres;
4. Press [P1] key to change distance and then press the [P4] or [P5] key within 1.5 seconds to enter
the read value. If you do not press the [P4] or [P5] key within this time limit, the machine will return to the previous display.
In this case, you can press the [P1] key again to enter or edit the data;
5. Measure the width of the wheel with the special gauge or read the value of the width indicated on the rim. The value of
the width can be in inches or millimetres according to the selected unit of measurement;
6. Press the [P2] key to change the width and press the [P4] or [P5] key within 1.5 seconds to enter
the read value. If neither of these two buttons is pressed in this time limit, the machine will return to the previous display.
In this case, you can press the [P2] key again to enter or edit the data;
7. Read the value of the diameter indicated on the rim or tyre. The value of the diameter can be in inches or millimetres
according to the selected unit of measurement;
8. Press the [P3] key to change the diameter value and then press the [P4] or [P5] key within 1.5
seconds to enter the read value. If neither of these two buttons is pressed in this time limit, the machine will return to the
previous display. In this case, you can press the [P3] again to enter or edit the data.
Figure F15.3: Manual acquisition of the wheel size: distance sensor fixing