Cormach MOTO MEC, Use And Maintenance Manual

Page: 14 / 36

Use and maintenance manual – 10/2016 Rev. 3 Page 8
7. INSTALLATION
7.1 Installation area
To install the machine you need a useful space on the basis of the information given in figure F7.1.
Figure F7.1
From working position, the user must be able to view the machine and the surrounding area.
INSTALLATION AREA MUST BE KEEP CLEAR BY POSSIBLE DANGEROUS OBJECTS.
UNAUTHORIZED PERSONNEL MUST NOT STAND NEAR BY THE WORKING AND INSTALLATION AREAS.
THE MACHINE MUST BE PLACED ON A HORIZONTAL SURFACE RATHER MADE OF CONCRETE OR TILED.
AVOID BREAKABLE AND ROUGH SURFACES.
SURFACE MUST ENDURE THE STRESS LOAD DURING THE MACHINE OPERATION.
THE MACHINE MUST BE SECURED TO THE GROUND WITH SCREWS AND EXPANSION PLUGS, ACCORDING
TO THE FOLLOWING INSTRUCTIONS.
THE USE OF THE MACHINE IS ONLY ALLOWED IN PLACES THAT DO NOT PRESENT RISKS OF EXPLOSION OR
FIRE.
7.2 Fixing the machine to the ground
MANDATORY GROUND FIXING.
1. Drill with manual drill for a depth of 35 mm. Make no. 3 holes and then clean them.
2. Push the expansion plugs into the holes with a small hammer blows.
3. Tight the nuts with torque wrench calibrated on 23 Nm (if you are not able to achieve this value the reason could be the hole is
too wide or the concrete is not solid enough).
Figure F7.2
1000
60
0
600