Artiglio 50
- Kit PAX System
31
GB
TECHNICAL DATA
ARTIGLIO 50 in configuration
for PAX System wheels
PAX System tyre types processed
- maximum dimension of the PAX tyre .....
cover 920 mm
- minimum diameter of the rim hole .40 mm
- minimum operating pressure ..........7 bar
- maximum operating pressure ..........10 bar
- force of the pneumatic cylinder (at 7 bar) .6500 N
Weight of PAX System
wheels kit ... 10 kg
ARTIGLIO 50, equipped for PAX wheels, can
operate on PAX System wheels (with a full-
width, clipped support) with the following
technical characteristics (for symbols A, B,
D, F, X and Y, see the design below).
PAX System wheels with full-width, clipped
support (fig.3)
- diameter (B) ............from 360 to 560 mm
- width (A) .......................... from 155 to 335
- inner offset (X) ..................... max 260 mm
- outer offset (Y) max .................... 330 mm
- hole diameter (D) ......from 40 to 105 mm
- diameter circumference fixing holes (F) .
from 98 to 170
3
B
D
Y
X
F
A
INSTALLATION
N.B.:
the PAX wheels Kit can only be in-
stalled on the ARTIGLIO 50 tyre changer.
The installation of the Kit for PAX wheels must only
be carried out by qualified personnel, authorised
by Corghi S.p.A. The installation by unqualified
personnel will lead to the loss of the guarantees
concerning the performance of the device.
ARTIGLIO 50 in configuration
for PAX System wheels
Tooling procedure
Fig.4 shows the ARTIGLIO 50 tyre changer fitted
for PAX System wheels.
The pre-setting of ARTIGLIO 50 in configuration
for PAX System wheels is obtained via the tooling
procedure described below:
- Disconnect the bead breaker disc from the
pneumatic system - fig.5.
- Remove the bead breaker disc by means of the
block formed by the blocking pin F - fig.5.
- Assemble the tool with the reversible roller
for PAX System wheels, and fix it so that the
blocking pin F enters the outer hole G - fig.6-
6a.
4
