36
Artiglio 50
- Kit PAX System
13A
G
13B
1
13C
2
Extracting the upper bead
Fig. 14 - (common procedure for Pax Sys-
tem with full-width or clipped support)
- Press the turntable rotation pedal and,
using the pneumatic command, gradually
begin the bead removal. At the same time,
lubricate the bead with a lubricating spray
(of the type recommended by the tyre
manufacturer) or, if no liquid lubricant is
available, with the special spray - fig. 14a.
- With the roller pressing against the bead,
you are advised to make the wheel com-
plete at least a couple of turns, in order
to soften the tension of the bead.
- In the space thus obtained between the
bead and the rim edge, the reglette will
be inserted - fig.14b.
- Insert the reglette as shown in fig.14c.
N.B.:
The reglette is inserted between the rim edge
and the bead (fig.15a). It is equipped with
a notch that allows you to insert the end of
the bead breaker lever.
ATTENTION
A reglette can be used for more than one
disassembly. It is necessary to check its
condition first, however. If the tang of the
reglette shows signs of wear and tear, you
are advised to replace it with a new one.
14A
