1
2
3
Safety Precautions:
1. Do not plug BioCube into an outlet or power
source until setup and installation is completed.
2. Visually inspect the aquarium and canopy prior to
installation to make sure it has not been damaged.
Canopy Assembly
1. Lift canopy from aquarium and visually check the
assembly to verify that the light lens cover,
compact fluorescent lamps and LED bar have not
been broken, damaged or dislodged (Figure 7).
2. Make sure that lamps are securely inserted into the
compact fluorescent endcaps and that the retaining
bands are attached to the lamp clips holding the
compact fluorescent lamps in place.
Wet/Dry Filter Assembly
1. Make sure that the BioCube filter cartridge is
properly inserted at the 1st chamber of the wet/
dry section (Figure 8).
2. Make sure that the overflow tray, bio-balls and
bio-ball strainer are properly placed inside the 2nd
chamber of the wet/dry section.
3. Make sure that the sponge filter is correctly placed
in the 3rd chamber of the wet/dry section.
4. Make sure that the water pump is properly
assembled and connected to the wet/dry return
output.
ASSEMBLY
FIGURE 7
FIGURE 8
Filter Cartridge
Canopy Assembly
LED Bar
Light Lens Cover
Overflow Tray
Bio-Balls
Bio-Ball Strainer
Water Pump
Sponge Filter
Aquarium Divider
Wet/Dry Filtration
Assembly
Wet/Dry Return Output
Surface Intake
Bottom Intake
Polished Reflector
Lamp
Clips
Compact Fluorescent
Endcaps
Compact Fluorescent
Lamps
Silicon Retaining
Bands
