NVR User Manual
30
If you connect internet through PPPoE, disable “Obtain an IP address automatically”
item and check PPPoE checkbox and then enter username and password. Once the setup
is completed, your NVR will automatically dial up into your network.
Step 5
: Test the effectiveness of the network by clicking “Test” button after you set up the
network.
Step 6
: If the network is well connected, please click “Apply” button to save the setting.
5.6.2 Email
To set up Email:
Step 1
: Enter into Menu
Setup
Network
Email tab. Refer to Fig 5-24:
Fig 5-24 Network Configuration-Email
Step 2:
Set SMTP Server and port.
SMTP Server/Port:
The name and port number of SMTP server. You can setup SSL check
(such as Gmail) according to actual needs.
Step 3:
Set sender’s address and password.
Step 4
: Set receiver’s email address and click “Test” button to test the validity of the mailbox.
5.6.3 Server
This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows:
Step 1
: In the server interface, select “Enable” as shown in the Fig 5-25.
Step 2
: Check the IP address and port of the transfer media server in the ECMS/NVMS. The
default server port for auto report is 2009. If it is modified, please enter into the transfer media
interface to check.
Step 3
: Enable the auto report in the ECMS/NVMS when adding a new device. Then
self-define device ID and input the remaining information of the device in the ECMS/NVMS.
Step 4
: Input the above-mentioned server IP, server port and device ID in the server interface.
Then click “Apply” button to save the setting. Now, the ECMS/NVMS system will
automatically connect this device.
