The Kill Weed works by heating the weed foliage with an intense
heat up to 1300ºC. This destroys the internal cell structure of the
plant causing it to wither and die.
Please read these instructions carefully before use and
keep in a safe place for future reference.
SAFETY WARNINGS
• When lit, only point at the ground, never hold the burner horizontally when lit.
• Only for use on surfaces that are non-combustible such as paving, stone,
pathways etc.
• Never use near dry grass, dry leaves, straw, bark, mulch, timber, thatched roofs
or anything that could catch fire, either from direct contact or from
sparks travelling.
• Keep away from fuel tanks, flammable liquids, petrol powered lawnmowers or
power tools etc.
• Observe any local authority guides/bans on the use of naked flames in times
of drought.
• Only for use outside.
• Only use in dry, still conditions.
• Only use in a well ventilated area.
• Protective clothing and eye protection should be worn.
• Keep away from children and pets.
• Never point the Kill Weed at a person.
• Do not touch the burner head after use as this will be hot. Allow to cool fully
before storage, especially in a wooden shed.
• Follow all safety warnings on your gas can (not supplied) carefully. Keep away
from direct sunlight and extremes of temperature.
• Gas cans should be fitted or removed in well ventilated areas, preferably outside,
and away from any source of ignition such as heat, flames, cigarettes etc.
•
DO NOT USE THE KILL WEED IF THE SEALING WASHER IS DAMAGED
OR MISSING.
• Do not perforate or burn the empty gas can – dispose of at your local recycling
centre.
• Do not leave unattended at any time.
• After turning off the valve to cease gas supply, be aware that the flame will stay
lit for a short time while the gas burns in the extension tube.
• Always ensure the burner is off when putting down.
• When lit, be aware that the flame may be difficult to see.
• Do not allow to get wet. Never immerse in water to cool.
• Precautions should be taken to protect any plant not to be killed.
• Protect any adjacent surface areas from heat damage.
• Do not use if any part of the Kill Weed is damaged in any way.
• Not for commercial use.
COMPONENTS
1.
Adjusting valve
2.
Ignition button
3.
Regulating Control, on/off valve
4.
Fitting for Butane Gas can (not supplied)
5.
Handle
6.
Tube extension
7.
Burner head
5.
Handle
3.
Regulating control
1.
Adjusting valve
4.
Fitting for butane gas can
2.
Piezo igniter
6.
Tube extension
7.
Burner head
Instructions
8610
