RECOMMENDED FUEL:
Only for use with a pressurised Butane Gas can with a screw
fitting (
Fig 4
).
OPERATING INSTRUCTIONS
• First read the safety warnings (see overleaf).
• Check sealing washer is in place.
• Ensure the on/off valve on the regulating control (
3
) is closed by
turning it clockwise.
• Hold the gas can vertically and twist on anti-clockwise (
Fig1
).
• Ensure that a good seal is made.
• Turn the on/off valve (
3
) to the left to a low setting.
Immediately press the ignition button to light the burner
• Adjust the valve to increase or reduce flame intensity.
• Gently waft the flame over the weed at a distance of
approximately 15cm distance (
Fig 2
). Do not burn the plant
completely, only the heat is needed. Most weeds will blacken and
die in a couple of days. Stronger weeds, woody stems and those
with long deep roots may require a repeat application.
REMOVING THE GAS CAN
• Ensure the on/off valve on the regulating control (
3
) is closed by
turning it clockwise.
• Hold the gas can vertically and turn clockwise (
Fig3
).
• After turning off the valve the gas will continue to burn from the
extension tube for a short while.
• Allow to cool completely before storage.
• Store the burner and gas can separately.
GAS LEAKS
If gas can be smelt or a gas leak is suspected, turn off the valve (
3
)
and check the sealing washer, or fixing of the can is secure. Never
check for leaks with a naked flame. If in doubt stop use and replace
the gas can.
PACKAGING
• Dispose of the packaging at your local recycling centre.
• Dispose of paper and carton separately from plastic bags at your
local recycling centre.
• Dispose of the item at the end of its lifespan at your local
authorised household waste recycling centre.
• Dispose of gas cans at your local recycling centre.
Instructions
8610
Minimum 15cm
Screw type
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Turn anti-clockwise
Turn clockwise
