Cordless Lawn Mower
11018
Instructions for Use
Please read and retain these instructions for future reference
v001: 31/10/17
Machine start,
immediately stop
Battery not fully charged
Charge battery
Key not inserted
correctly/fully
Fit correctly
Battery not inserted
(properly)
Insert battery
Machine functions
intermittently
Internal wiring of machine
damaged
Contact Service Agent
Battery not fully charged
Charge battery
Machine leaves
ragged finish and/
Motor obstructed
Height of cut too low
Increase height of cut(see “Adjusting the
Cutting Height”)
Cutting blade dull
Replace the blade(see “Blade Maintenance”)
Possible clogging
Check underneath the machine and clear out as
necessary (always wear gardening gloves)
Blade fitted upside down
Refit blade correctly(see “Blade Maintenance”)
Area of cut (battery
duration) not large
enough
Height of cut too low
Increase cut height and walk slower
Grass too high
Increase cut height and walk slower
Grass wet or damp
Wait until grass is dry and walk slower
Grass is dense
Increase cut height , walk slower and cut more
frequently
An additional battery can be
purchased from an
authorized customer service
agent for garden products
Contact Service Agent
Cutting blade not
rotating while
machine switched on
Cutting blade obstructed
Switch off machine clear obstruction (always
wear gardening gloves)
Blade nut/bolt loose
Tighten blade nut/bolts
Excessive
vibrations/noise
Blade nut/bolt loose
Tighten blade nut/bolts
Cutting blade damaged
Contact Service Agent replace the blade
No charging
procedure possible
Battery contacts
contaminated
Clean the battery contacts (e.g. by inserting and
removing the battery several times) or replace
the battery
（
Batteries can be purchased to
service agents
）
The battery is defective, due
to a disconnection in the
battery
Replace the battery
（
Batteries can be purchased
to service agents
）
Charger plug into the
AC power access, the
Power LED is not lit
Mains plug of battery charger
not plugged in (properly)
Insert mains plug (fully) into the socket outlet
Socket outlet, mains cable or
battery charger defective
Check power supply voltage, if necessary, a
battery charger, an authorized inspection station
contact customer service
After Usage/Storage:
Cleaning the mower
In order to reduce the risk of electric shock, do not expose the mower to water. The underside of the mower
deck should be cleaned after each use, because grass clippings, leaves, dirt, and other debris will accumulate,
which will cause rust and corrosion.
