Cordless Lawn Mower
11018
Instructions for Use
Please read and retain these instructions for future reference
v001: 31/10/17
Use the following procedure to remove and re-place the blade:
Fig. 7
1)
While wearing strong padded gloves,
wedge a block of wood between the
blade and the mower deck in order to
prevent the blade from turning when
the nut is being removed.
2)
Using a 19 mm wrench or socket,
loosen the blade nut (
Fig.7 No.1
) and
remove the blade (
Fig.7 No.3
) . Turn
the nut “COUNTER-CLOCKWISE” to
loosen it and “CLOCKWISE” to tighten
it.
3)
Remove the blade nut, the washer
(
Fig.7 No.2
), the blade, and blade
holder (
Fig.7 No.4
).
4)
To re-install the blade, position the
blade with the cutting edges toward the
ground. Assemble the holder, the
blade, the washer, and the nut as
shown. Using a 19 mm socket or
wrench, turn the blade nut
"CLOCKWISE” in order to secure the
blade.
Troubleshooting:
The following chart lists problem symptoms, possible causes and corrective action, if your machine does not
operate properly. If these do not identify and correct the problem, contact your service agent.
•
Warning! Switch off and remove the key before investigating any fault
Problem
Possible Cause
Corrective Action
The machine does
not work
Possible clogging
Check underneath the machine and clear
obstruction (always wear gardening gloves)
Battery not fully charged
Charge battery
Battery not inserted
(properly)
Insert the battery
Grass too long
Increase height of cut and tilt machine to reduce
starting load
Safety switch damage
Contact Service Agent
Over current protection has
activated
Allow motor to cool /increase height of cut
Battery too hot/cold
Allow to cool/warm
Safety switch key not inserted
correctly/fully
Fit correctly
