9
1. Description
The Wire-Wrap Tool 14YB3 is equipped with a security insulation and is powered by 230 V
mains power. The universal motor has a ball bearing on both sides. The carbon brushes are
relaceable. The tool yields an interference suppression of 12 dB below EMI class N; thus it is
suitable for application with telecommunication devices. The index angle can be adjusted
without tools in stps of 45° after loosening the adjustment nut, allowing for adaptation to the
handling of the wires and their outgoing direction. The wrap bits and sleeves can also be
exchanged without tools. While model 29315AA3 has a rigid shaft the wrap pawl is displaced
axially against the spring pressure during the wrap process. Wrap bits and sleeves are available
for all current wires and wrap pawls. Wires from AWG 30 to AWG 22 can be processed with
CSW bits (for combined cutting and stripping). The wrap bits and sleeves are not included in
standard delivery and have to be ordered separately.
Power supply:
230 V, 50-60 Hz
Power consumption:
30 W
Intermittent operation:
2 sec. ON / 18 sec. OFF
Wrapping range:
AWG 30 to AWG 18
Fuse:
315 mA slow
EMI suppression:
12 dB below class N
2. Operation
For the installation of the wrap bit and the sleeve, the nut has to be loosened. First insert the
wrap bit into the collet, then the sleeve. The sleeve has to locked into the retention pin. Then
fasten the nut manually while the tool is operating. If you want to change the index angle,
loosen the adjustment nut and rotate the whole collet assembly into the desired position.
3. Maintenance
Disconnect mains power plug before carrying out any maintenance work. The assembly of
the tool has to be performed as shown in the exploded view. When mounting it is important
to align motor and gearing carefully. The planetary gearing and the slip friction clutch have to
be lubricated after each dismounting with grease type ESSO BACON 2. For replacing the
carbon brushes lift the spring clips, replace the used brushes by new ones and put the spring
back into place.
4. Safety notice
WARNING! The following basic safety rules and measures must be observed to prevent
electrical shocks, injury and fire hazards when working with electrical tools. Please read
these safety instructions carefully before you use this electric tool. Keep these safety
instructions in a convenient place for immediate reference.
5. Accessories
For wrap bits and sleeves refer to the Wire-Wrap Catalogue.
6. Extent of delivery
The tool is delivered without accessories.
Exploded view: see page 23
7. Safe work
1. Keep your work place tidy.
Untidy work areas increase the risk of accidents.
2. Take environmental factors into account.
Do not expose electrical tools to rain. Do not use electrical tools in a moist or damp environment
or in the vicinity of flammable liquids and gases.
3. Protect yourself against electrical shocks.
Avoid body contact with earthed parts such as pipes, radiators, stoves, refrigerators, etc.
4. Keep tools well away from children.
Do not allow other people to touch the electric tool or the cable. Other people should not be
standing in the work area.
5. Ensure that electrical tools are alway safely stored.
Electric tools that are not being used must be stored in a dry, high place, well out of reach of
children or in a locked place.
GB
14YB3_09._00
22.05.2003, 11:21 Uhr
9
