1
2
pre amp
HP1 & 2
channel
fader
OL
Lim.
pan
pot
A B C D
bus assign
pre fader
pre amp
HP1 & 2
channel
fader
pan
pot
pre fader
MS
limiter
link
A
B
C
D
post fader
post fader
stereo block diagram
A
B
C
D
OL
Lim.
CH 1/3/5
CH 2/4/6
CH
link
CH out (1/3/5)
CH out (2/4/6)
post jack
post jack
PFL
PFL
STEREO INPUT CHANNEL
Any pair of mono channels can be converted to stereo pairs.*
The cosmetic difference is that the Pan out switches are
replaced with Link & MS Decode switches with LEDs above.
1. Link:
Both channels (odd & even) are linked together with one
stereo fader on the odd channel - the even channel fader is
disconnected from the circuit. ‘Link on’ also links the two
limiters.
2. MS DEC:
MS Decode - The even channel output is inverted to bus B
only. Both pan pots should be centered. With equal gain,
the M/S mic configuration is decoded to 50%.
Odd channel = mid, Even channel = side.
The result will be:
A bus = M + S = L, B bus = M - S = R
The stereo image width can be changed by altering the gain
of one channel.
Note: A & B assign switches should be on for both channels.
C & D busses are now pre pan pot (& inverter), allowing a non decoded MS
mic configuration to be recorded, pre or post fader to C & D busses.
MS mic configuration can also be recorded via the pre fader channel outs.
Note: For decoding MS to the monitor only - see output section.
*A retrofit kit is available.
CSST-STEREO MODULE
MODEL CS306
Right Page
Right Page
5
June 2006
