4.
2.
1.
●
●
●
●
The drain hose can't be fluctuant
2.
The water outlet can't be placed in water in
order to drain smoothly.
●
●
Step 5:
Connect outdoor electric wire
wall
U-shaped curve
drain hose
the drain hose
can't raise
upwards.
The water outlet
can't be placed
in water
NOTICE
The drain hose
can't be fluctuant
The water
The wiring board is for reference only, please refer
to the actual one.
outlet can't be
fluctuant
NOTICE
Remove the wire clip; connect the power con-
NOTICE
After tighten the screw, pull the power cord slightly
to check if it is firm.
Never cut the power connection wire to prolong or
shorten the distance.
nection wire and signal control wire (only for
cooling and heating unit) to the wiring terminal
according to the color; fix them with screws.
Step 6:
Neaten the pipes
Fix the power connection wire and signal con-
trol wire with wire clip (only for cooling and h-
eating unit).
1.
The through-wal height of drain hose shoul
not be higher than the outlet pipe hole of in-
door unit.
2
4
Slant the drain hose slightly downwards.
The drain hose can't be curved, raised and
fluctuant, etc.
15~20
30~40
45~55
60~65
70~75
1/4''
3/8''
1/2''
5/8''
3/4''
Tighten the union nu t with torque wrench
by referring to the sheet below.
Hex nut diameter
Tightening torque(N m)
.
The pipes should be placed along the wall, bent
reasonably and hidden possibly. Min. semidiam-
eter of bending the pipe is 10cm.
If the outdoor unit is higher than the wall hole,
you must set a U-shaped curve in the pipe
before pipe goes into the room, in order to
prevent rain from getting into the room.
Indoor unit connection
L
Indoor unit connection
L
N
L
N
POWER
blue
N(1)
2
3
blue
brown
brown(black)
black
yellow-
green
yellow-green
brown
black
blue
24K :
blue
N
POWER
brown
(black)
yellow-
green
N(1)
2
3
L
N
yellow-
green
09K
、
12K
、
18K:
