Revised: 15/02/16
31/03/2016
27
6)
Shamic goods come with guarantees that cannot be excluded under Australian Consumer Law.
The purchaser is entitled to a replacement or a refund for a major failure and compensation for
any reasonably foreseeable loss or damage. The purchaser is also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount
to a major failure.
7)
This warranty applies only to units purchased from an authorised dealer and the duration of this
implied warranty, including merchantability, applicable to this Coonara heater is limited to the
duration of the foregoing warranty.
8)
Before Shamic Sheetmetal (Aust.) Pty.Ltd. will recognise or accept a claim under this warranty,
you must provide proof of purchase. On purchase of the heater, despatch your warranty card to
Shamic Sheetmetal (Aust.) Pty.Ltd.
9)
Your authorised dealer must be notified of any defect in the heater, for investigation of the
claim. Your authorised dealer will be able to explain the process of making a warranty claim and
any costs associated with returning goods. In the event where a remedy is necessary and the
claims under warranty are accepted, the purchaser may be required to return the goods to the
authorised dealer for repair, replacement or refund.
CARE OF YOUR CLEAR VIEW & BAROSSA GAS HEATER
This appliance requires minimal maintenance, however, it is recommended that a
qualified person make a full service and check annually.
The Bottom fascia air grill should be removed by unscrewing the two screws and the fan
vacuumed annually.
To clean the appliance, simply wipe over with a damp cloth. Do not use solvents or
abrasive cleaning agents.
Before making a service call check that:
1 - Electrical power is on
2 - Gas is turned on
3 - There are no obstruction /blockages of the flue terminal
Summary of Contents for Barossa
